How to Remove Camera Head, Spring and Sonde - Insight | Vision

How to Remove Camera Head, Spring and Sonde - Insight | Vision

Section: 
Instructions, Videos

How to remove the Camera Head, Spring and Sonde on your Insight Vision Opticam or Vutek sewer camera system in less than 60 seconds
Using the large end of the S-Tool, match the notch with the end of the spring, firmly grab the camera head and turn counterclockwise until the camera head comes free from the spring.
Remove the strain reliefs from the notches in the camera head. Unscrew the bushing and your camera head is removed.
Using the small end of the S-Tool, insert into notch and push the spring away from you while holding the termination firmly.
Finish unscrewing the spring by hand.
Unscrew the sonde from the push cable and pull apart. Pull out the strain reliefs then push the sonde through the spring and pull out.
Insight | Vision is an advanced inspection manufacturer for many industries but mainly for pipes, drains and sewers lines.

Product Page: 
Push Camera System